A-A-52029
Performance. The container shall conform to the requirements specified in ISO 1496/1 without damage or permanent deformation.
Interior cargo securing devices.
Closed side wall. The container shall be fitted with eight lashing rings at the junction of the closed side wall and bottom rail; one ring in each corner of the side rail and six evenly spaced along the side rail. The lashing rings shall be vertically mounted so as not to impinge on the loading area of the container. Rings shall be fully welded to the bottom side rail. Each ring shall be able to withstand a pull of not less than 6000 pounds at 45 degrees from the vertical. The lashing rings shall be able to handle 2 inch wide steel strapping.
Door opening side. The door opening side of the container shall be fitted with eight flush fitting lashing rings countersunk through the floor or bottom side rail immediately inside the inner face of the container doors when in the closed position. The lashing rings shall be positioned corresponding to those mounted on the closed side wall and be fully welded to the junction of the bottom side rail and floor support bearer. Each lashing ring shall have a pull strength at 45 degrees from the vertical of not less than 6000 pounds. Restraint fittings shall be able to handle 2 inch wide steel strapping.
Surface preparation. All steel components both inside and out, shall be abrasively blasted to a near white Steel Structure Painting Council (SSPC)-10. Equivalent chemical cleaning may be proposed. The cleaned surface shall be free from oil, grease, dirt, mill scale, rust, corrosion products, oxides, paints or any other foreign matter. Very light shadows or very slight streaks caused by mill scale, oxides or other slight discolorations on the finished surface shall be acceptable. At least 95 percent of each square inch of surface area shall be free of all visible residues and the remainder shall be limited to the slight discoloration mentioned above.
Primer coat. The container shall be primed with either zinc rich or zinc chromate primer.
Top coat. The top coat shall be enamel, alkyd, semi-gloss. The exterior finish color shall be in accordance with FED-STD-595, color number 24084 (olive drab). Interior finish color shall be light grey. The final coating thickness shall be not less than 135 microns dry film thickness.
Marking. The container shall be identified and marked in accordance with ISO 6346.
Workmanship. All parts, components, and assemblies of the container including castings, forgings, molded parts, stampings, seals, and sealing agents, machined surfaces, and welded parts shall be clean and free from any defects that will reduce the capability of the container to meet the requirements specified herein. Any components and assemblies which have been repaired or modified to overcome deficiencies shall not be used without prior specific approval of the contracting officer. External surfaces shall be free from burrs, slag, sharp edges, and others except where shall edges and corners are required. The internal cargo
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business