A-A-52032B
3. Performance. The container shall conform to the requirements specified in ISO 1496/1 without damage or permanent deformation.
3.1 Workmanship. All parts, components, and assemblies of the container including castings, forgings, molded parts, stampings, seals and sealing agents, machined surfaces, and welded parts shall be clean and free from any defects that will reduce the capability of the container to meet
the requirements specified herein. Any components and assemblies, which have been repaired or modified to overcome deficiencies shall not be used without prior specific approval of the contracting officer. External surfaces shall be free from burrs, slag, sharp edges, and corners except where sharp edges and corners are required. The internal cargo space shall be free from sharp protrusions that could damage cargo or personnel.
3.2 Metric products. Products manufactured to metric dimensions shall be considered on an equal basis with those manufactured using inch-pound units, provided they fall within specified tolerances using conversion tables contained in the latest revision of FED-STD-376 (see 7.2.3), and all other requirements of this CID are met.
4. REGULATORY REQUIREMENTS. The offeror/contractor is encouraged to use recovered materials to the maximum extent practicable, in accordance with paragraph 23.403 of the Federal Acquisition Regulation (FAR) (see 2.1 and 7.2.2).
5. PRODUCT CONFORMANCE. The products provided shall meet the salient characteristics of this CID, conform to the producer's own drawings, specifications, standards, and quality assurance practices, and be the same product offered for sale in the commercial marketplace. The Government reserves the right to require proof of such conformance (see 7.1).
5.1 Responsibility for inspection. The contractor is responsible for the performance of all inspections (examinations and tests).
6. PACKAGING. Preservation, packing, and marking shall be as specified in the contract or order (see 7.1).
7. NOTES.
7.1 Ordering data. The contract or order should specify the following:
a. CID document number and revision.
b. If materials (includes color) are other than that used in commercial manufacture
(see 2.1 and 2.3.14).
c. If standard container is as otherwise specified (see 2.2.1). d. When load retainers are required (see 2.3.2).
e. If forklift pockets are required (see 2.3.7).
f. When placard holders are required (see 2.3.14).
7
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business