A-A-52033A
2.1.4 Identification of materials and finishes. The contractor shall identify the specific materials, material finishes or treatments for use with component or subcomponents, and shall make information available upon request to the contracting officer or designated representative. Materials not specified shall be in accordance with federal, military or national technical society, association or institute specifications or standards.
2.2 Description. The container shall be noncollapsible, of a permanent character and suitable for repeated use. The container shall be a steel 4 ft 3 inch (in.) (129.5 centimeters (cm)) external height (includes roof bows), 8 ft (2.44 m) external width, ISO lCX container with a drop end
door at one end. The container shall comply with the requirements of ISO 1496/1 (see 7.2.3).
2.2.1 Standard product. Except as otherwise specified herein (see 7.1), the container shall be the standard product of the contractor. The container shall be new and unused.
2.2.2 Weight, ratings and dimensions. The tare weight of the container shall be the minimum practical and shall not exceed 5500 pounds (lb) (2495 kilograms (kg)). The gross weight rating shall be 52 910 lb (23 999 kg). Dimensions, tolerances, and diagonal differences of the container shall meet the requirements for a 20 ft nominal length container as specified in ISO 668
(see 7.2.3). When viewed from the door end, the cross sectional profile of the interior cargo space shall provide a true rectangular envelope without obstruction, having a minimum width of
89 in. (226 cm), consistent from the floor surface to a height of not less than 41 in. (104 cm)
above the floor surface.
2.3 Construction. The container shall be constructed so as to be free of any recesses or voids in which contraband can be concealed or where moisture can accumulate. No part of the container shall protrude beyond the outside surfaces of the corner fittings.
2.3.1 Door. A drop end door shall be hung within the rear end frame and shall provide a clear opening conforming to IS0 668 (see 7.2.3). The drop end door shall be capable of opening a minimum of 180 degrees. The internal surface of the door shall be plated with rolled steel having non-skid rail figures on the top surface. The door shall be capable of withstanding a load of 8000 lbs (3628.7 kg) per tire footprint, 16 000 lb (7257.5 kg) axle load over a contact area of not more than 22 square inches (in.2) (141.9 square centimeters (cm2)) per tire footprint. When closed, the door shall be sealed in such a manner as to prevent moisture entry into the container. The door structure shall satisfy the requirements of Transport International des Routiers (TIR) (see 7.2.4).
2.3.2 Side walls, end wall and door. The steel side walls, end wall and door may be of the interior or exterior post type, corrugated or of smooth skin construction. The side walls, end wall and door shall withstand loading in accordance with ISO 1496/1, except that the end wall and door each shall withstand an internal loading equal to the full uniformly distributed payload.
2
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business