PPP-B-1672E
3.2.2.1 Style D.
The pack shall be constructed in accordance with figure 3. The box and cushioning shall be
constructed in accordance with the triple slide box style (modified TS) and ASTM
D5118/D5118M except that the middle box shall be omitted and the sleeve shall have the
overlap stitched, stapled, or glued (see 3.2.4 and 3.2.5) outside the side panel. The top of the box
shall be the large portion of the box where the manufacturer's joint or seam is located with the
open flutes facing downward.
3.2.2.2 Style E.
The box and cushioning shall be constructed in accordance with figure 3 with the one-piece
folder style OPF and ASTM D5118/D5118M, except that the inner end flaps shall meet when
closed.
3.2.3 Type III, Style G. The telescoping and encapsulated packs shall be constructed in accordance with style FTC of ASTM D5118/D5118M with appropriate cushioning as shown on figure 4.
3.2.4 Type IV, Style B. The horizontal star packs shall be constructed in accordance with the
DBLCC shown on figure 5. The box shall be constructed in accordance with 3.2.1.2.
3.2.5 Bonding of components. Adhesive specified in 3.1.5 shall be applied to cushioning components described herein to provide a forty-five (45) percent, +/- five (5) percent contact area to adhere the cushioning to each of the box components, to permit recyclability of boxes. For type IV, style B on figure 5, and type III, style G on figure 4, the top cushioning pads shall be centered and adhered to the inside face of the top cap. In addition, style G side and end cushioning pads shall be arranged and adhered in accordance with the applicable view on figure
4. For type II packs (see figure 3), the cushioning shall be centered and adhered to the inside faces of the slide.
3.3 Dimensions. All box sizes shall be based on and identified by the inside dimensions of the innermost shell (such as box, tube, or slide) and shall be accurate to within 1/8 inch (3 mm). These dimensions shall be cited in the sequence of length, width, and depth. The center of the die-cut star cavity for type I and type IV shall be within 1/2 inch (13 mm) of true center.
3.4 Markings. Markings shall be either printed or stenciled in black letters. All markings shall be in the upright direction and shall be clear and legible.
3.4.1 Compliance and certificate markings. Compliance and certificate markings shall be imprinted on all boxes in accordance with ASTM D5118/D5118M except as specified herein. Data markings such as the National Stock Number (NSN), inside dimensions, and any other which are required to be printed elsewhere on the box shall not be repeated in the compliance and certificate markings. The compliance and certificate markings shall be placed on the bottoms of the boxes.
3.4.1.1 Type I, type III, and type IV packs. The following markings shall be in characters of a size not less than 1/2 inch (13 mm) high, except that the National Stock Number (NSN) may be not less than 3/8 inch (10 mm). The markings shall be centered on the lower half of two opposite faces of the style A packs parallel to the closure seam formed by the outer flaps and style G pack covers. The markings shall be on two opposite faces of the bottom cap of the style B and style C packs. The markings format shall be as follows:
7
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business